We research products independently. When you buy through our links we may earn a commission. How we make money
Indoor air quality

Furnace Carbon Monoxide: 8 Essential Safety Steps for Every Home

Furnace carbon monoxide safety matters in every home with a gas, oil or propane furnace, boiler, water heater or other fuel-burning appliance. Carbon monoxide (CO) is a colorless, odorless gas produced when fuel burns. A properly working, properly vented furnace sends it outside. A cracked heat exchanger, blocked flue, backdrafting or poor maintenance can let it into your home.

This guide covers eight essential steps to protect your household, the warning signs of a problem, and exactly what to do if a carbon monoxide alarm sounds.

Key takeaways

  • Install CO alarms on every level of the home and outside sleeping areas, and test them monthly.
  • Have fuel-burning furnaces inspected every year before heating season, as the EPA recommends.
  • Keep flues, vents and intakes clear, and never block combustion air openings.
  • If a CO alarm sounds, get everyone outside to fresh air and call 911 or the fire department from outside.

In this guide

How furnaces can produce carbon monoxide

Fuel-burning furnaces create combustion gases inside a sealed heat exchanger, then vent them outdoors through a flue or vent pipe. CO can enter your home when:

  • The heat exchanger cracks, letting combustion gases mix with house air.
  • The flue is blocked by debris, nests, snow or corrosion.
  • Venting is disconnected or improperly installed.
  • Backdrafting occurs: strong exhaust fans, leaky return ducts or a tight house depressurize the furnace area and pull flue gases back in. ENERGY STAR notes leaky ductwork may cause backdrafting of combustion gases and recommends a combustion safety test after duct sealing.
  • Burners are dirty or out of adjustment, producing more CO.

8 essential furnace carbon monoxide safety steps

1. Install CO alarms

Put CO alarms on every level of the home, including the basement, and outside each sleeping area. Follow the manufacturer’s placement instructions. Combination smoke/CO alarms are available.

2. Test alarms monthly and replace on schedule

Press the test button monthly. Replace batteries as directed and replace the alarm when it reaches its end-of-life date, typically 5 to 10 years.

3. Get an annual furnace inspection

The EPA recommends having fuel-burning furnaces, stoves and fireplaces inspected for proper functioning and serviced before each heating season to protect against CO poisoning. A technician should check the heat exchanger, burners, flue, venting and safety controls, and measure combustion if needed.

4. Keep vents and flues clear

Outside, keep furnace vent and intake pipes clear of snow, ice, leaves and nests. Inside, don’t store items against the furnace or flue.

5. Don’t block combustion air

Furnaces in closets and small rooms need combustion air openings. Never seal them or store items in front of them.

6. Seal return ducts near the furnace

Return leaks near a gas furnace or water heater can depressurize the room and pull flue gases back. Seal the return plenum and ducts. See sealing return air ducts.

7. Get a combustion safety test after major changes

After duct sealing, air sealing, adding powerful exhaust fans or replacing equipment, ask for a combustion safety test to confirm flues still draft properly.

8. Never use outdoor equipment indoors

Never run generators, grills, camp stoves or vehicles in a garage, basement or near windows. These are among the most common causes of CO poisoning.

If your CO alarm sounds: get everyone, including pets, outside to fresh air immediately. Call 911 or your fire department from outside. Don’t go back in until emergency responders say it’s safe. If anyone has symptoms, seek medical attention.

Warning signs of a CO problem

  • CO alarm sounding.
  • Symptoms in more than one person or pet that improve away from home, such as headache, dizziness, nausea, weakness or confusion.
  • Soot around the furnace or vent.
  • A yellow, flickering burner flame instead of steady blue (on furnaces where flames are visible).
  • Excess moisture or condensation on windows near the furnace.
  • The furnace pilot or burner repeatedly going out.

These signs aren’t a diagnosis; they’re reasons to call a professional and, if an alarm sounds, to leave the house immediately.

Furnace age and CO risk

Older furnaces aren’t automatically dangerous, but heat exchangers can crack with age and repeated overheating. Restricted airflow from a clogged filter or blocked returns makes overheating more likely. Keep filters fresh and airflow healthy. See HVAC static pressure.

Other fuel-burning appliances

Water heaters, gas dryers, fireplaces, wood stoves and gas ranges can also produce CO. Keep their venting clear, vent dryers outdoors, and use the range hood when cooking with gas. See indoor dryer vent.

A worked example

During a fall tune-up, a technician finds a furnace vent pipe partly disconnected in the basement after a recent water heater replacement, and soot near the joint. The house has no CO alarms. The technician reconnects and seals the vent, performs a combustion safety test, and the homeowner installs CO alarms on each level and outside the bedrooms that afternoon.

Common furnace problems that create carbon monoxide

  • Cracked heat exchanger. Cracks can allow combustion gases into the airstream. Technicians check with visual inspection, cameras and combustion analysis.
  • Blocked flue or vent pipe. Bird nests, debris, snow or a disconnected vent can send exhaust back into the house.
  • Poor combustion. Dirty burners or incorrect gas pressure produce more CO. A yellow, lazy or flickering flame instead of a steady blue one is a warning sign.
  • Backdrafting. Strong exhaust fans or a tight house can pull exhaust back down the flue of a natural-draft furnace or water heater.

Where to put CO alarms

  • On every level of the home, including the basement.
  • Outside each sleeping area, close enough to wake people.
  • Follow the manufacturer’s placement instructions, and replace alarms at the end of their rated life, often 5 to 10 years.
  • Test alarms monthly and replace batteries as directed.

Combination smoke and CO alarms are fine as long as they’re placed correctly for both hazards.

Symptoms of carbon monoxide exposure

Early symptoms can feel like the flu: headache, dizziness, nausea, weakness and confusion. Symptoms that improve when you leave the house and return when you come back are a strong warning sign. If your CO alarm sounds or anyone has symptoms, get everyone outside to fresh air and call 911 or the fire department. Don’t go back in until responders say it’s safe.

Annual furnace checks that matter

Ask your technician to:

  • Inspect the heat exchanger and burners.
  • Check the flue and vent pipe for blockages and proper slope and connections.
  • Measure combustion and check for CO in the flue and the living space.
  • Test safety switches, including the flame sensor and rollout switches.

An annual inspection is the most practical way to catch furnace carbon monoxide risks before they become emergencies. If you smell a burning smell from vents, see burning smell from vents.

Furnace carbon monoxide: FAQ

Can a furnace leak carbon monoxide?

Yes, if the heat exchanger cracks, the flue is blocked or disconnected, or backdrafting occurs.

Where should I put carbon monoxide alarms?

On every level of the home and outside each sleeping area, following the manufacturer’s instructions.

How often should a furnace be inspected?

Every year before heating season.

What should I do if my CO alarm goes off?

Get everyone outside to fresh air and call 911 or the fire department from outside.

Do electric furnaces produce carbon monoxide?

No. Electric furnaces don’t burn fuel. But other fuel-burning appliances, attached garages and generators can still produce CO, so alarms are still recommended.

The bottom line

Furnace carbon monoxide safety comes down to alarms, inspections and venting. Install and test CO alarms, have fuel-burning equipment inspected every year, keep flues and intakes clear, seal returns near the furnace, and get a combustion safety test after major changes. If an alarm sounds, get out and call for help. For more, see the EPA’s duct cleaning guidance, which also recommends annual furnace inspections.